arduino i2c with wire library transmission speed

In R3 of original Arduino UNO, there are two more pins near Digital IO Pin 13 (near the USB socket), dedicated to SDA and SCL. The A4 pin acts as SDA while the A5 pin acts as SCL. If you take a look at the pinout of Arduino UNO from the tutorial “ ARDUINO UNO PINOUT”, Analog Input pins A4 and A5 have an alternative function of I2C. I2C in ArduinoĪrduino supports I2C Communication. For more information on that, visit “ Basics of I2C Communication”.

I made an extensive tutorial on basics of I 2C Communication. Using this address, master selects a particular slave for data transmission (send or receive) and the selected slave responds according to request. Each slave device connected to the I2C bus has a unique 7-bit address.

I2C network supports multiple masters and multiple slaves (but we usually see single master and multiple slaves). The clock signal is also supplied by the master. Bus Masters are responsible for sending and receiving data to and from the slave devices. There are two types of devices that connect to the I2C Bus: Master and Slave. Data is transmitted through the SDA line while the SCL line is used to synchronize the devices with the clock signal.īoth these bus lines are open-drain drivers and hence you have to use pull-up resistors to keep them HIGH. The I2C Bus consists of two wires called the Serial Data (SDA) and the Serial Clock (SCL). This may not seem much but it is sufficient for interfacing sensors, memories and displays at small distances. Using I2C, you can transmit data at rates 100 kbit/s (clock 100 kHz – Standard Mode), 400 kbit/s (clock 400 kHz – Fast Mode), 1 Mbit/s (clock 1 MHz – Fast Mode Plus) and 3.4 Mbit/s (clock 3.4 MHz – High Speed Mode).

Hence, it is sometimes also known as TWI (Two Wire Interface). I2C or I 2C is short for Inter-Integrated Circuit, a synchronous serial communication protocol developed by Phillips for communication between a fast Microcontroller and relatively slow peripherals (like Memory or Sensors) using just two wires.

Arduino i2c with wire library transmission speed